Specifications

A single, full-duplex Gigabit Ethernet interface

Clock Speed: 33/66 MHz
Maximum burst transfer rate: 100 MBps (approx)
Steady state transfer rate: 75 MBps
CompactPCI bus mode: Master/slave

High-density 2-millimeter pin-and-socket connectors, which provide 32- and 64-bit PCI signals

SC fiber connector

Maximum power consumption:	10 Watts 5v (+5/-3%) supply current 1.15 A typical 50 mV
-	3.3v (+5/-3%) supply current 0.24 A typical 50 mV
-	+12v (+/-5%) supply current 10 mA max. 240 mV

Temperature:	Operating: 0 to 55 degrees C (+32 to +131 degrees F) Non-operating: -40 to 75 degrees C (-40 to +158 degrees F)
Relative humidity:	Operating: 5 to 95% non-condensing (45 degrees C, wet bulb temperature) Non-operating: 0 to 95% non-condensing 10 degrees C/hour
Altitude:	Operating: -1000 to +15,000 ft. Non-operating: -1000 to +50,000 ft.
Shock:	Operating: 10g, 1/2 sine wave, 11 msec. Non-operating: 60g, 1/2 sine wave, 11 msec.
Vibration, peak to peak displacement:	Operating: 0.005 in. max. (5 to 32 Hz) Non-operating: 0.1 in. max. (5 to 17 Hz)
Vibration, peak acceleration:	Operating: 0.25g (5 to 500 Hz) (Sweep rate = 1 octave/min.) Non-operating: 0.25g (5 to 500 Hz) (Sweep rate = 1 octave/min.)

Compact IEEE-standard 3U Eurocard form factor

Length: 160 mm (6.30 inches)
Width: 100 mm (3.94 inches)
Height (not including PCB): Primary component side: 13.40 mm (max.)
Back component side: 1.52 mm (max.)
Weight: 184.27 grams

Meets or exceeds the following requirements:

cPCI Spec Compliance	Full compliance with cPCI specifications
EMC:	Complies with the following requirements of the EMC Directive 89/336/EEC: EN55022:1995/CISPR22:1997 Class A EN55024:1998: EN61000-4-2 4 kV (Direct), 8 kV (Air) EN61000-4-3 3 V/m EN61000-4-4 1.0 kV Power Lines, 0.5 kV Signal Lines EN61000-4-5 1 kV Line-Line, 2kV Line-Gnd Power Lines EN61000-4-6 3 V EN61000-4-8 3 A/m EN61000-4-11 Pass EN61000-3-2:1995 Pass EN61000-3-3:1995 Pass
Safety:	Complies with the following requirements of Low Voltage Directive 73/23/EEC: EC Type Examination Certificates: EN60950:1992, 2nd Edition
Supplementary Information:	Tested and complies with all the requirements for the CE Mark

Supported software

The software requirements for cPCI cards are a superset of Sun's current PCI adapter offerings. By using the same driver, Sun is able to minimize the support/sustaining of these adapters. The key cPCI-related software requirements include:

• Single driver for both PCI and CompactPCI
• Support of Solaris[tm] 8 Operating System (such as IPv6)
• Full hot-swap capabilities, including dynamic reconfiguration
• Support for the Solaris Operating Environment hot-swap controller
• Firmware on serial and Fcode PROMs

Supported hardware

Sun Fire 3800 server