Skip to Content Sun and Oracle Channel Sun How to Buy Log In United States [Change] English

Sun Storage 7310 Unified Storage System Power Calculator

From $40,165.00 (US)

Download the Simulator

The intent of the power calculator is to provide guidance for estimating the electrical and heat loads for typical operating conditions. It should not be used to calculate power or HVAC requirements. Instead, please use the appropriate site planning guide to allow for proper allowances.

You MUST allow electrical and cooling headroom for unforeseen circumstances, component upgrades, and increased computational loads. Please allow for worst-case power conditions. Actual power consumption will vary from the sample workload used in the power calculator. These include, but are not limited to, the factors below. Each of these factors may cause significant differences in power consumption:

Actual workload and its fluctuations
Ambient temperature
Cooling patterns
Excessive inlet temperature
Humidity
Operating systems features
Power management settings

The "Sample Power" results shown below (if using 100% workload) represent Server power consumption measurements with CPUs at 100% utilization running SPECjbb2005. HPC workloads may consume more power than the commercial workload used in this calculator. If shown for this calculator, the "Active Idle Power" results below represent power consumption measurements taken from Servers with Operating Systems booted and stabilized, yet running at minimal utilization. Sample results shown are representative of measurements taken with room temperatures below 25°C. System power can vary depending upon Hardware/Software configurations and environmental conditions. For precise results, actual measurements based upon the exact Hardware/Software/Environmental conditions are recommended.

Configure your Sun Storage 7310 system and calculate your Sun server total power consumption!

Sun Storage 7310 Power Calculator

Item

Quantity

Notes

Base Appliance

Select Server Type

Clustering

Select clustering for base appliance only. Assumes no additional storage arrays, but adds an identically configured base appliance.

Storage

10TB Disk and 2 SSDs Array
11TB Disk and 1 SSD Array
20TB Disk and 4 SSDs Array
22TB Disk and 2 SSDs Array
23TB Disk and 1 SSD Array
24TB Disk Array
12TB Disk Array

Select Array
(Min 1, Max 4)
Max 3 Arrays with SSDs (non-clustered)
Max 4 Arrays with SSDs (clustered)

Solid-state drives (SSD): Readzilla

Select number of SSDs
(Min 0, Max 6 per base appliance)

Tape Backup Controller

Select number of Tape Backup Controller
(Min 0, Max 1 per base appliance)
Clustering reduces available PCIe slots

Network Interface Cards

Select Network Interface Cards
(Min 0, Max 1 per base appliance)
Clustering reduces available PCIe slots

Quad Ethernet adapter

Select Quad Ethernet adapter
(Min 0, Max 1 per base appliance)
Required for clustering

Indicate Workload (%):

Select Workload range
(1% - 100%)

Sample Results

Item	Active Idle Power	Sample Power
Total Power of System (Watts)	(estimated)	(estimated)
Total Power of System (BTU/HR)	(estimated)	(estimated)

Legal Notice: This calculator is subject to change without notice and is provided "as is" without warranty of any kind, express or implied. Sun Microsystems does not make any representations regarding the use, validity, accuracy or reliability of the tool. The entire risk arising out of the use of this tool remains solely with the customer. In no event shall Sun Microsystems be liable for any direct, consequential, incidental, special, punitive or other damages, even if Sun is negligent or has been advised of the possibility of such damages, arising from use of the tool or the information provided herein.